Steps Necessary To Pass The H35-910-ENU Exam from Training Expert DumpsKing [Q135-Q160]

Share

Steps Necessary To Pass The H35-910-ENU Exam from Training Expert DumpsKing

Valid Way To Pass Huawei-certification's  H35-910-ENU Exam

NEW QUESTION 135
Which of the following is the adjustment point of the antenna downtilt?

  • A. Lifting pole
  • B. Upper bracket
  • C. Feeder interface
  • D. Lower bracket

Answer: B

 

NEW QUESTION 136
For the convenience of work, employees C used mobile phones to take photos of some training materials and project cases on Huawei's intranet, so that they can be inquired in peacetime, not counting information security violations.

  • A. TRUE
  • B. FALSE

Answer: B

 

NEW QUESTION 137
What is the role of the positioning rope?

  • A. Use when climbing the tower
  • B. Fix the body for easy work
  • C. Fix the material

Answer: B

 

NEW QUESTION 138
What is the binding method of the hanger during the lifting process?

  • A. In order to solve it, you don't need to tie it tightly or hang it firmly.
  • B. Must be tied or hanged securely, lock the shackle, lock the insurance agency

Answer: B

 

NEW QUESTION 139
Which of the following is the key basis for the division of operational responsibility for the operation of the equipment power bus into the client room power supply?

  • A. Contract Engineering Interface
  • B. Supervision instructions
  • C. The negotiation result of the consultation meeting
  • D. Customer requirements

Answer: A

 

NEW QUESTION 140
Which of the following statements about the installation of antenna feeder cables is wrong?

  • A. Power cables, signal cables, and optical fibers must be placed on the channel when they are routed at the bottom of the cabinet or outside the cabinet. The protective sleeve should enter the interior of the cabinet and the sleeve should be tied and secured.
  • B. The outdoor cable is laid out with white straps. The spacing of the cables is even, the tension is moderate, and the orientation is consistent. Reserve 3~5mm.
  • C. Unused holes need to be blocked with waterproof spigot.
  • D. The RRU power cord connector has a positive (+) pole connected to the black line and a negative (-) pole connected to the blue line.

Answer: B

 

NEW QUESTION 141
Which of the following devices can be used to install the BBU?

  • A. AAU
  • B. IBBS200D
  • C. RFC
  • D. APM30

Answer: D

 

NEW QUESTION 142
What are the following stages of the "high-risk operation" process? (Multiple choice)

  • A. Preparation stage
  • B. Verification phase
  • C. Implementation phase
  • D. Confirmation phase
  • E. Closed loop phase

Answer: A,B,C,E

 

NEW QUESTION 143
Regarding account password management, which of the following belong to network security violations? (Multiple Choice)

  • A. Attack, destroy customer network, crack customer account password
  • B. Reserve an undisclosed account in the product or service provided
  • C. Customer's account and password are authorized by the customer's written authorization
  • D. Leak and spread the account and password of the customer network

Answer: A,B,D

 

NEW QUESTION 144
When installing the antenna at the site, how many degrees should the antenna be within the protection zone of the lightning rod?

  • A. 90 degrees left and right
  • B. 45 degrees left and right
  • C. 60 degrees left and right
  • D. 30 degrees left and right

Answer: B

 

NEW QUESTION 145
UMPT cannot insert to the No.6 slot position of BBU.

  • A. False
  • B. True

Answer: A

 

NEW QUESTION 146
Which of the following modules is the base station main control board?

  • A. UMPT
  • B. LBBP
  • C. UBBP
  • D. UPEU

Answer: A

 

NEW QUESTION 147
Which of the following boards does the basic configuration of the BBU mainly include? (Multiple choice)

  • A. Baseband board
  • B. Main control board
  • C. Expansion board
  • D. Power board
  • E. Fan board

Answer: A,B,D,E

 

NEW QUESTION 148
Which of the following are high-risk operation contents in the following operations? (Multiple Choice)

  • A. The data in the device enclosure expansion is cut into the network.
  • B. Equipment handling process
  • C. Device patching
  • D. Replace the power cable after the equipment in the cabinet is expanded.
  • E. Hardware installation of cabinets and cabinets

Answer: A,C,D,E

 

NEW QUESTION 149
Regarding the description of the laying cable, what is the correct statement below? (Multiple Choice)

  • A. Generally, the protective ground wire is yellow-green, and if the cable length is insufficient, it can be cascaded.
  • B. Make sure that there is no crossover when all cables are laid out, and the distance between the signal cable and the power cable is greater than 3cm.
  • C. Use the appropriate strength when laying cable, and do not use too much force.
  • D. The OT terminal should be tightly pressed and the connection should be insulated.

Answer: B,C,D

 

NEW QUESTION 150
Which of the following statement is true about the input voltage of the BBU3900?

  • A. +24V
  • B. +36V
  • C. -48V
  • D. -24V

Answer: C

 

NEW QUESTION 151
When driving, what kind of telephone call is we absolutely forbidden for the driver?

  • A. Speakerphone
  • B. Handheld phone

Answer: B

 

NEW QUESTION 152
What are the safety requirements for the operation on the tower? (Multiple Choice)

  • A. Make sure the seat belt is fastened to 2 different points
  • B. It is not allowed to climb a tower alone. It must be accompanied by a caregiver.
  • C. The tools to be carried should be packed in the bag to avoid falling.
  • D. The seat belt must be inspected before climbing the tower, and the climbing tower must wear a seat belt.

Answer: A,B,C,D

 

NEW QUESTION 153
Which terminal of the DCDU is connected to the blue power cable?

  • A. GND
  • B. NEG(-)
  • C. RTN(+)

Answer: B

 

NEW QUESTION 154
Which of the following modules that do not belong to the BBU?

  • A. FAN
  • B. SLPD
  • C. UMPT
  • D. UBBP

Answer: B

 

NEW QUESTION 155
The CPRI cable must be connected correctly at one time. Otherwise, the RRU may be abnormal.

  • A. TRUE
  • B. FALSE

Answer: B

 

NEW QUESTION 156
Vehicle safety does not need to be checked before each drive.

  • A. False
  • B. True

Answer: A

 

NEW QUESTION 157
Which of the following modules cannot be installed in an APM 30H cabinet?

  • A. BBU3900
  • B. EPU
  • C. RRU
  • D. SPLU

Answer: C

 

NEW QUESTION 158
What is the meaning of the EHS representative? (Multiple choice)

  • A. Health
  • B. Environment
  • C. Monitoring
  • D. Security

Answer: A,B,D

 

NEW QUESTION 159
Which module/board does the BBU not contain?

  • A. Power module
  • B. Main control board
  • C. LBBP
  • D. Battery module

Answer: D

 

NEW QUESTION 160
......

All H35-910-ENU Dumps and HCS-Wireless Hardware Installation(Written) Training Courses: https://www.dumpsking.com/H35-910-ENU-testking-dumps.html