[Oct 12, 2025] Pass CCNP Security 300-730 Exam With 240 Questions
Ultimate Guide to Prepare Free Cisco 300-730 Exam Questions and Answer
What Career Opportunities and Salary Will You Get?
After passing the related exams and earning the CCNP Security or the Network Security VPN Implementation certifications, the candidates can develop their careers in the field of network security and VPN execution. Such validations will open up various job opportunities for aspiring candidates with generous annual pay. For instance, applicants may choose to opt for the following roles with the annual average salaries as covered by Payscale.com below:
- Systems Engineer: $80,658;
- Network Analyst: $59,725;
- IT Team Leader: $88,440;
Cisco 300-730 certification exam is an essential credential for IT professionals who work with VPN technologies. By passing 300-730 exam, candidates demonstrate their expertise in implementing secure VPN solutions using Cisco technologies. Implementing Secure Solutions with Virtual Private Networks certification can help IT professionals advance their careers, increase their earning potential, and gain recognition from their peers and employers.
NEW QUESTION # 102
Refer to the exhibit.
Based on the configuration output, what is the VPN technology?
- A. DMVPN
- B. multicast VPN
- C. site-to-site
- D. L2VPN
Answer: D
NEW QUESTION # 103
A network administrator wants the Cisco ASA to automatically start downloading the Cisco AnyConnect client without prompting the user to select between WebVPN or AnyConnect. Which command accomplishes this task?
- A. anyconnect modules value default
- B. anyconnect ask none default anyconnect
- C. anyconnect ssl df-bit-ignore enable
- D. anyconnect ask enable default anyconnect
Answer: B
NEW QUESTION # 104
Refer to the exhibit. A network engineer is troubleshooting a new DMVPN configuration. The network connectivity between the hub and spoke is working as it should, but users cannot access VPN resources. Which action resolves the issue?
- A. Unblock IP protocol 50 on devices between the VPN devices.
- B. Review ISAKMP packets on devices between the VPN devices.
- C. Ensure that the NHS is configured on the tunnel interface.
- D. Ensure that the IPsec profile is configured on the tunnel interface.
Answer: D
Explanation:
The output of show crypto isakmp sa shows that all security associations are in the
"MM_NO_STATE" state. This indicates that IKE Phase 1 negotiation did not complete successfully, preventing IPsec tunnel establishment. A common cause of this issue in DMVPN (Dynamic Multipoint VPN) is that the IPsec profile is missing or incorrectly applied on the tunnel interface.
NEW QUESTION # 105
Which two types of web resources or protocols are enabled by default on the Cisco ASA Clientless SSL VPN portal? (Choose two.)
- A. CIFS
- B. HTTP
- C. VNC
- D. RDP
- E. ICA (Citrix)
Answer: A,B
Explanation:
You will not see an option of RDP, VNC, SSH, and/or Telnet unless the appropriate client/server plug-in has been installed first.
https://www.cisco.com/c/en/us/td/docs/security/asa/asa94/config-guides/cli/vpn/asa-94-vpn- config/webvpn-configure-gateway.html
NEW QUESTION # 106
A Cisco ASA is configured in active/standby mode. What is needed to ensure that Cisco AnyConnect users can connect after a failover event?
- A. The vpnsession-db must be cleared manually.
- B. AnyConnect client must point to the standby IP address.
- C. AnyConnect images must be uploaded to both failover ASA devices.
- D. Configure a backup server in the XML profile.
Answer: C
NEW QUESTION # 107
Which command must be configured on the tunnel interface of a FlexVPN spoke to receive a dynamic IP address from the hub?
- A. ip address pool
- B. ip address dhcp
- C. ip address negotiated
- D. ip unnumbered
Answer: C
Explanation:
interface Tunnel0
ip address negotiated
tunnel source GigabitEthernet1
tunnel mode ipsec ipv4
tunnel destination 1.1.1.5
tunnel protection ipsec profile IPSEC_PROFILE
NEW QUESTION # 108
What are two advantages of using GETVPN to traverse over the network between corporate offices? (Choose two.)
- A. It supports multicast.
- B. It is a highly scalable any to any mesh topology.
- C. It supports a hub-and-spoke topology.
- D. It has unique session keys for improved security.
- E. It has QoS support.
Answer: A,B
NEW QUESTION # 109
A network engineer configured Secure Client VPN for a vendor to provide access to internal resources for a migration project. A pool of 192.168.100.0/28 has been assigned and a local database for user authentications has been configured. An image of Cisco Secure Client Client
4.7 for Windows has also been added. The vendor allocated 10 engineers to the project, and all users were able to connect to the corporate resources. After some time, the vendor added another six resources to the project. After this change, engineers from the vendor reported frequent disconnections.
Which action resolves the issue?
- A. Increase the amount of IP addresses in the pool.
- B. Allocate more Cisco Secure Client licenses to the ASA.
- C. Upgrade new users to Cisco Secure Client 4.7.
- D. Add the new users to the local database on the ASA.
Answer: A
Explanation:
The assigned VPN IP pool (192.168.100.0/28) provides only 14 usable IP addresses (excluding network and broadcast addresses). Initially, with 10 vendor engineers, the pool was sufficient.
However, when six more users were added, the total number of users increased to 16, exceeding the available IP pool.
Since VPN connections require an available IP address from the assigned pool, some users may experience frequent disconnections or inability to connect due to IP exhaustion.
NEW QUESTION # 110
Which method dynamically installs the network routes for remote tunnel endpoints?
- A. reverse route injection
- B. CEF
- C. route filtering
- D. policy-based routing
Answer: A
NEW QUESTION # 111
Refer to the exhibit.
Client 1 cannot communicate with client 2. Both clients are using Cisco AnyConnect and have established a successful SSL VPN connection to the hub ASA. Which command on the ASA is missing?
- A. same-security-traffic permit intra-interface
- B. dns-server value 10.1.1.3
- C. same-security-traffic permit inter-interface
- D. dns-server value 10.1.1.2
Answer: A
NEW QUESTION # 112 
Refer to the exhibit. The customer can establish a Cisco AnyConnect connection without using an XML profile.
When the host "ikev2" is selected in the AnyConnect drop down, the connection fails. What is the cause of this issue?
- A. Primary protocol should be SSL.
- B. UserGroup must match connection profile.
- C. The HostName is incorrect.
- D. The IP address is incorrect.
Answer: B
Explanation:
Section: Troubleshooting using ASDM and CLI
Explanation/Reference: https://community.cisco.com/t5/security-documents/anyconnect-xml-settings/ta-p/3157891
NEW QUESTION # 113
Which configuration construct must be used in a FlexVPN tunnel?
- A. EAP configuration
- B. IKEv1 policy
- C. IKEv2 profile
- D. multipoint GRE tunnel interface
Answer: C
NEW QUESTION # 114
Which type of VPN technology is being used when the ssl trust-point <trustpoint name>
<interface name> command is configured?
- A. DMVPN
- B. GETVPN
- C. SSL Remote Access VPN
- D. IPsec site-to-site VPN
Answer: C
Explanation:
The command ssl trust-point <trustpoint name> <interface name> is used in SSL VPN (Secure Sockets Layer Virtual Private Network) configurations. This command specifies the trustpoint (which contains the SSL certificate) that will be used for encrypting SSL VPN sessions. The trustpoint is a reference to a Certificate Authority (CA) that provides authentication for SSL connections.
NEW QUESTION # 115
Which redundancy protocol must be implemented for IPsec stateless failover to work?
- A. SSO
- B. VRRP
- C. GLBP
- D. HSRP
Answer: D
Explanation:
Reference:
https://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-negotiation-ike-protocols/17826- ipsec-feat.html
NEW QUESTION # 116
An administrator is designing a VPN with a partner's non-Cisco VPN solution. The partner's VPN device will negotiate an IKEv2 tunnel that will only encrypt subnets 192.168.0.0/24 going to
10.0.0.0/24. Which technology must be used to meet these requirements?
- A. DMVPN
- B. VTI
- C. GETVPN
- D. crypto map
Answer: D
NEW QUESTION # 117
What action does the hub take when it receives a NHRP resolution request from a spoke for a network that exists behind another spoke?
- A. The hub updates its own NHRP mapping.
- B. The hub sends back a resolution reply to the requesting spoke.
- C. The hub waits for the second spoke to send a request so that it can respond to both spokes.
- D. The hub forwards the request to the destination spoke.
Answer: D
NEW QUESTION # 118
A Cisco ASA is configured in active/standby mode. What is needed to ensure that Cisco AnyConnect users can connect after a failover event?
- A. The vpnsession-db must be cleared manually.
- B. AnyConnect client must point to the standby IP address.
- C. AnyConnect images must be uploaded to both failover ASA devices.
- D. Configure a backup server in the XML profile.
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/security/asa/asa90/configuration/guide/asa_90_cli_config/ ha_active_standby.html
NEW QUESTION # 119
Drag and drop the code snippets from the right onto the blanks in the configuration to implement FlexVPN. Not all snippets are used.
Answer:
Explanation:
NEW QUESTION # 120
An engineer would like Cisco AnyConnect users to be able to reach servers within the 10.10.0.0/16 subnet while all other traffic is sent out to the Internet. Which IPsec configuration accomplishes this task?
- A. Option B
- B. Option C
- C. Option A
- D. Option D
Answer: A
NEW QUESTION # 121
A second set of traffic selectors is negotiated between two peers using IKEv2. Which IKEv2 packet will contain details of the exchange?
- A. IKEv2 CREATE_CHILD_SA
- B. IKEv2 IKE_SA_INIT
- C. IKEv2 INFORMATIONAL
- D. IKEv2 IKE_AUTH
Answer: C
Explanation:
Section: Site-to-site Virtual Private Networks on Routers and Firewalls Explanation/Reference:
NEW QUESTION # 122
A network engineer must design a clientless VPN solution for a company. VPN users must be able to access several internal web servers. When reachability to those web servers was tested, it was found that one website is not being rewritten correctly by the ASA.
What is a potential solution for this issue while still allowing it to be a clientless VPN setup?
- A. Set up a smart tunnel with the IP address of the web server.
- B. Set up a NAT rule that translates the ASA public address to the web server private address on port 80.
- C. Set up a WebACL to permit the IP address of the web server.
- D. Set up Cisco AnyConnect with a split tunnel that has the IP address of the web server.
Answer: A
NEW QUESTION # 123
Refer to the exhibit.
Cisco AnyConnect must be set up on a router to allow users to access internal servers 192.168.0.10 and 192.168.0.11. All other traffic should go out of the client's local NIC. Which command accomplishes this configuration?
- A. svc split include 192.168.0.0 255.255.255.0
- B. svc split exclude 192.168.0.0 255.255.255.0
- C. svc split include acl CCNP
- D. svc split exclude acl CCNP
Answer: C
NEW QUESTION # 124
A network administrator is setting up a Cisco ASA to authenticate clientless SSLVPN users using an internal Microsoft Active Directory server. When the configuration is complete and the administrator attempts to connect to the clientless SSLVPN, authentication fails. Which action resolves the issue?
- A. Correct the login distinguished name or login password under the aaa-server configuration.
- B. Configure the ASA to connect to the LDAP port being listened to on the Microsoft Active Directory server.
- C. Add the user account the administrator is attempting to log in with to the database.
- D. The administrator must use the correct password for the user account they are attempting to log in with.
Answer: A
Explanation:
The error message in the log "Simple authentication for [email protected] returned code (49) Invalid credentials" indicates that the username or password configured for LDAP authentication is incorrect.
On Cisco ASA, when integrating with Microsoft Active Directory (AD) via LDAP, the ASA must bind to the AD server using a valid distinguished name (DN) and password to perform user authentication queries. If the DN or password is incorrect, authentication will fail.
NEW QUESTION # 125
......
There are no formal prerequisites for this certification exam, but the chances that you will pass it will be much higher if you fulfill the following criteria:
- For starters, it will be very beneficial for the candidates if they have a good understanding of the site-to-site and Remote Access VPN options;
- Next, they should also have some experience managing and navigating firewalls and Cisco routers;
- Lastly, the individuals should have some experience with different firewall and Cisco router command modes.
All in all, there are no strict requirements to fulfill, so you can whether have some prior experience to make things easier for you or can learn the exam content with great deliberation and try to master it to succeed. In any of these scenarios, your level of preparation and the skills you have gained will ultimately make a difference in your final result.
Implementing Secure Solutions with Virtual Private Networks Practice Tests 2025 | Pass 300-730 with confidence!: https://drive.google.com/open?id=1CmOIbKGG-sK5sKjKVvIXR7LphmbMpky8
Pass 300-730 Tests Engine pdf - All Free Dumps: https://www.dumpsking.com/300-730-testking-dumps.html
